Plug & Play TRD Pro Camo Fender Flare Wire Harness for 2022+ Tundra

Plug and Play wire harness kit for 2022+ Tundra TRD Pro Fender Flares.

Braided cable-wrapped wire harness with waterproof connectors for all 4 fender flares.

1 fuse box add-a-circuit harness for the front fender marker lights

1 tail light splitter harness for the rear fender marker lights. (fits both premium sequential and standard OEM tail lights)

2 fender flare harnesses with 2 leads on each. 

These are NOT 3D printed connectors. They are actual waterproof connectors designed perfectly for the fender flare marker lights.

Fender Flares are not included. If you need the fender flares as well, please see our fender flare kit here.

Fender Flare Install Instructions

Rear Wiring Instructions:

Remove a tail light by opening your tailgate and removing both bolts with a 10mm socket. Unplug the 6 pin tail light harness and replace with our supplied splitter harness. Plug the tail light harness back into the other side of the splitter harness. Plug the 2 lead harness into the 2 pin connector coming off the tail light splitter harness and run the 2 lead fender flare cable to each fender flare.

Front Wiring Instructions:

Open your hood. Locate the passenger side fuse box. Remove the cover. Locate a fuse labeled ENG IGR. Replace the pulled fuse into the empty slot on the supplied fuse tap and put the fuse tap (with both slots now occupied) into the ENG IGR fuse slot in the fuse box. Run the 2 lead fender flare cable to each fender flare and plug into the 2 pin connector off the fuse box. Use the supplied O ring terminal to ground the circuit by pulling the 10mm bolt with white wires on the sidewall of the engine bay near the fuse box. Fasten the O ring terminal to the bolt and fasten the bolt back on the sidewall with the O ring attached beneath it.